Maximum distance for CCTV Camera Installation

It all depends on what security system are you planning on using, PoE (power over ethernet) type, Analog type, IP type.

PoE type

Specific devices that could power & transfer data from/ to the CCTV cameras; think of it as a hybrid sort of IP only that it’s not required any longer to get a separate power cable to power up the cameras with 12V.

FTP (foil screened twisted pair) cable is what I would recommend and RJ45 connectors using all pairs.

Keep in mind that some cameras require more than 12V when powered up. Some cameras require 24V or more. Make sure the device that offers PoE capabilities can have managed PoE ports. If not, use 12V cameras.

The maximum distance of the cable for PoE should be =100m.

Analog type

For the Analog type CCTV cameras, most coaxial cables can transfer the BNC connector signals up to 200m. Do not believe for a second when they say it goes to 500m.

And even if it’s true, the quality & performance of the signal might be disappointing. I’d say keep it low, 200m.

The best cable that I have used so far is the RG6 with power cable attached to it. I have yet to see a drop in quality in any of the installations I did and the power cable attached to it is excellent as well.

If you are planning on going to 400m or 500m, don’t forget to buy a power supply with potentiometer voltage increasing capabilities.

It might be required to go to 13 – 14V if 12V is not enough. Or maybe install a local power supply near the cameras to avoid the pain in the ass in case the distance is too high.

How do you notice when it’s not enough? One or multiple cameras will show NO VIDEO signal.

IP type

Undoubtedly, the best camera system is by far the IP type. The quality that the IP cameras offer is astounding.

It is required the same approach as the Analog type, with power cable going alongside FTP (foil screened twisted pair) cable used for internet, network, RJ45 connectors.

The maximum signal distance from a switch to a camera, for example, should be around 150m, excluding the power cable distance which should work at that distance as well.

However, the signal could extend to additional 150m increments only through switches installed at each distance milestone.

The ideal solution for the power cable would be to try powering the camera locally with a 12V power supply if the distance is too big.